Minggu, 20 Mei 2018

Sponsored Links

The Straight Scoop: The Inside Story on Drag Race Wheel Alignments ...
src: www.onallcylinders.com

In automotive engineering, toe, also known as tracking, is the symmetric angle that each wheel makes with the longitudinal axis of the vehicle, as a function of static geometry, and kinematic and compliant effects. This can be contrasted with steer, which is the antisymmetric angle, i.e. both wheels point to the left or right, in parallel (roughly). Negative toe, or toe out, is the front of the wheel pointing away from the centerline of the vehicle. Positive toe, or toe in, is the front of the wheel pointing towards the centerline of the vehicle. Toe can be measured in linear units, at the front of the tire, or as an angular deflection.

In a rear wheel drive vehicle, increased front toe in provides greater straight-line stability at the cost of some sluggishness of turning response. The wear on the tires is marginally increased as the tires are under slight side slip conditions. On front wheel drive vehicles, the situation is more complex.

Toe is usually adjustable in production automobiles, even though caster angle and camber angle are often not adjustable. Maintenance of front end alignment, which used to involve all three adjustments, currently involves only setting the toe; in most cases, even for a car in which caster or camber are adjustable, only the toe will need adjustment. One related concept is that the proper toe for straight line travel of a vehicle will not be correct while turning, since the inside wheel must travel around a smaller radius than the outside wheel; to compensate for this, the steering linkage typically conforms more or less to Ackermann steering geometry, modified to suit the characteristics of the individual vehicle.


Video Toe (automotive)



Road-rail vehicles

The front rail wheels of road-rail vehicles are often set to toe-in by a distance of 6 mm over 1 metre. Unlike other forms of rolling stock, Road-rail vehicles do not always have a common axle between the rail wheels and the toe-in angle prevents the vehicle from hunting when on-rail.


Maps Toe (automotive)



Interaction with camber

When a wheel is set up to have some camber angle, the interaction between the tire and road surface causes the wheel to tend to want to roll in a curve, as if it were part of a conical surface (camber thrust). This tendency to turn increases the rolling resistance as well as increasing tire wear. A small degree of toe (toe-out for negative camber, toe-in for positive camber) will cancel this turning tendency, reducing wear and rolling resistance. On some competition vehicles such as go-karts, especially where power is extremely limited and is highly regulated by the rules of the sport, these effects can become very significant in terms of competitiveness and performance. Toe-in and toe-out give the steering stability.


M y a n m a r   H u n k s: Nay Toe by Photo La Min Naing
src: 4.bp.blogspot.com


See also

  • Camber angle
  • Caster angle
  • Vehicle dynamics

DIY Alignment: Setting Toe with the String Method - YouTube
src: i.ytimg.com


References


HOW BAD PARTS AFFECT CAR TOE ALIGNMENT
src: www.automobileglobe.com


External links

  • Camber, Caster, Toe - What does it all mean?
  • Toe and Race Car Suspension Tuning
  • Wheel Alignment: a Short Course
  • Tirerack: Alignment, Thrust, Camber, Caster, Toe

Source of the article : Wikipedia

Comments
0 Comments